In addition
to RG-2400®, below are some of our other coatings.
To learn more about which is most appropriate in
your
specific application contact Polyguard.
CA-9™ and CA-14™ CORROSION-CONTROL
COATINGS
Polyguard Products offers these corrosion-control coatings to protect
piping systems from corrosion. CA-9 and CA-14 coatings, when applied
to piping, prevent moisture from contacting the pipe and corroding
it, even if the coating is in direct contact with moisture. CA-9 and
CA-14 are products used especially to protect oil and gas transmission
lines from corrosion, extending the useful life of a piping system.
CA-9 was tested against 129 other corrosion-control coatings by two
major oil companies and finished as the #1 coating. Both are brush-applied.
Visit www.polyguardproducts.com for more information.
WET-SET™ CORROSION-CONTROL
COATING
Polyguard offers this corrosion-control coating to protect piping systems
from corrosion when moisture is prevalent. A two-component epoxy mixture
(1-to-1 ratio) cures in wet environments; when applied to piping it
prevents moisture from contacting the pipe and corroding it, even if
the pipe is in direct contact with moisture. Wet-Set will cure even
if you coat a short piece of pipe and drop it into a bucket of water.
This coating is brush-applied approximately 20 MILS thick and is very
fast setting. Visit www.polyguardproducts.com for more information.
